Design House 153791 Guida di Installazione

READ AND SAVE THESE INSTRUCTIONSOWNERS INSTRUCTION MANUALFOR DUAL MOUNT FAN’SINSTALLATIONOPERATIONMAINTENANCEThese instructions are suitable forUL/cUL

1. Four wires are connected to the top of the fan.Black: ” Hot” Power/Live for the fanBlue: “ Hot” Power/ Live for the light kitWhite: “Common”/Neutra

1. Place screw through the blade and start the screw into the blade arm repeat thisprocedure without tightening the screw until all 3 screws have been

1. Locate two wires in the switch housing (white and blue labeled “ for light”).2. Connect them to the light kit wire connectors (Fig. 12)White to whi

1.Remove switch housing screws and then remove bottom cap of switch housingshell on fan.2.Locate two wires in the switch housing (white and blue label

1. Restore electrical power by turning on the electricity at the main fuse box.2. Turn on the wall switch.3. Your fan has two controls on the switch h

1. The fan natural movements may cause some connections to work loose. Aclicking or rattling noise is a certain sign of loosening screws. Check the su

MAINTENANCEFAN DOES NOT START1. Check all fuses or circuit breakers. Replace if MISSING.2. Turn off electrical power and check all wire connections to

5. If the above does not eliminate the wobble, clip a balancing kit on any one ofblade about the middle of blade edge. Let fan run. If it is still wob

Safety Tips -----------------------------------------------------------------------------------2Unpacking Your Fan -----------------------------------

TABLE OF CONTENTS 1. To avoid possible electric shock, turn off the electricity at the main fuse box orcircuit panel before you begin the fan installa

SAFETY TIPS1. Unpack your fan and check the contents. Do not discard the carton. Ifwarranty replacement or repair is ever necessary the fan should be

1. If there is an existing outlet box, ensure it is clearly marked” Suitable For FanSupport”. If not, it must be replaced with an approved one.2. Secu

1. To avoid possible electrical shock, be sure electricity is turned off at the mainpower panel before wiring.All wiring must be in accordance with Na

1 Slide the canopy on the downrod(Fig.6) Thread the power leads from the fanthrough the canopy and downrod. Take extra care not to pull on power wires

3. Tighten motor set screw. Check the strength of this connection (pre-tightened atfactory) by holding the motor housing in position and turning the d

1. Put 2 screws in the hanger bracket. Leaving them partially out. (Fig. 9.1).2. Remove three of the six screws and lock washers (every other one) fro